I bought myself two of your Red i lasers 1 x 30 – 06 & 1 x 270, After I fitted 2 x new Burris Telescopes on both hunting rifles, I used your Red i bore sight on 25 meters to zero the scopes.

My 30 – 06 Bruno (100 meters) on the shooting range was on the dot after 1 shot, I used 3 shots just to make sure, and was very impressed.

My 270 Musgrave (100 meter) on the shooting range was ± 40 mm to the right and ± 55 mm to low with 2 shots, I adjusted my scope and 3 shots after that it was perfect on the dot.

I must admit that my friends and I are saving a lot of money on ammunition.

Your Red i is a must have for each and every hunter, because anything can happen while transporting your Rifle to the hunting fields and it is easy to use the Red i just to make sure your rifle and the scope is 100 % according to the chart that comes with the Red i.

Your after sale service is also excellent because after I bought these bore sights, I accidentally drop the 30 – 06 Red i and Daan replaced it immediately for me, I know that it was not guaranteed for this kind of incident, but (Thanks again Daan) I appreciate it.

Kind Regards

Monty Kroezen

The battery-powered Red-i is machined from high-grade brass and stainless steel to the precise dimensions of the specific cartridge. It’s fitted with a high-quality laser, aligned and checked to be 100% accurate on a centre jig. Place the Red-i into the chamber like a cartridge. Close the chamber (as by closing the bolt of a bolt-action rifle) for the built-in switch to activate an intense laser beam that shines down the barrel, perfectly aligned with the centre axis.

Bore sighting aligns the optical axis of the scope sight mounted above the barrel with the bore’s axis, giving the reference point where the bullet’s flight path first intersects it, about 25m from the muzzle.

The Red-i enables you to check the alignment of the scope sight or other sighting system anywhere, any time – without firing a shot. Carried in your pocket like any other cartridge, it saves time, ammunition, expense, and occasionally your shoulder from recoil. It’s an essential weapon accessory for any shooter.

The Red-i can be used as a reference bore sight for a rifle already sighted with a specific load at a specific range. Document the load and sighting distance, then insert the Red-i into the chamber and close the bolt to activate the laser. Aim at a target 25m away and measure the laser dot’s position in relation to the scope’s crosshairs – how many millimetres above or below, left or right. This position will stay the same for this specific load and sighting distance, and you’d never have to repeat the procedure.

Red-i-Laser stocks laser bore sights for over 100 rifle cartridges from .223 Remington (5,56 NATO) to .700 Nitro Express, shotgun cartridges, wildcat cartridges and handgun cartridges larger than calibre 9mm.

Article written by C.J. Nel
Assistant Editor
Farmer’s Weekly

Chamber load (internal) bore sights are our specialty but front load bore sights are available for those calibers not suited for the chamber load e.g. .22 long, 4.5 and 5.5 air rifle. Chamber bore sights range from caliber .17 to a 700 Nitro, all shotgun calibers and handgun calibers 9mm and larger.

Battery powered and made from high quality brass and stainless steel, the Red-i bore sight is manufactured by aligning the internal laser according to the actual external dimensions of the cartridge, thus complying with the single most important aspect of any good laser bore sight.

Our clients may also rest assured that every bore sight is individually calibrated for accuracy by using our uniquely designed centre jig.